B. H. Hanson
B. H. Hanson
Ph. (570) 689-4561 Fax (570) 689-4562
Aircraft/Helicopter Engine Product Line
Hanson/Zenoah PUH and RC Helicopter Engines
Pro Heli Engine - 4 HP, pump bulb carburetor, lightened ported piston, balanced flywheel and blue printed cylinder - $425
Pro Plus Heli Engine - same specs as above, plus a modified crankshaft for a very smooth running heli engine - $445
3D-Max - Our most powerful heli engine. 4.8 HP, pump bulb carburetor, hi compression ported cylinder, lightened ported piston, trued and balanced crankshaft and flywheel for smooth running, metal recoil ring - $495
All horsepower ratings are with Hanson Heli tuned pipes
Heli engines available in 231/260 PUH and G231/260 RC style.
Click image to enlarge
Aircraft
Our Zenoah Aircraft engines are modified to give you a trouble free, light weight engine with easy starting abilities. All engines feature an efficient electronic ignition that will run for about two hours on a 4.8 or 6 volt 600 M.A. battery pack. Engine performance is enhanced with the removal of excess crankshaft weight and modified spark curve. Also included on all engines is a safety hub that is stronger then the factory supplied propeller hub and a rotated carburetor on a custom intake manifold for a straight pull linkage. Hand starting is easy with a hot spark at 1 RPM ! All engines are custom made, pre run and adjusted for trouble free use. While we keep these engines in stock there may a two week wait for delivery depending on demand.
Click image to enlarge
Above left - G26. Our 260 SPU weighs about 2.5 lbs and makes 17 lbs of thrust with a
Mejzlik 18-6 prop. RPM is 9000 with no muffler and 8200 with muffler. Engine is supplied as pictured along with firewall mount, factory muffler, manual and plug wrench. - $425.00
Above center - G38. Our G38 SPU weighs in at 3.5 lbs. Best performance is with a 20-8 or 18-10 prop.
Spark retard is linkage controlled for easy starting. Engine is supplied with no muffler, custom firewall mount, factory manual and plug wrench. - $475.00
Above right - G62. Our G62 SPU is trimmed and lightened to just over 4 lbs.
This powerhouse turns a 22-10 prop 7000 RPM and makes 28 lbs of thrust. Engine is supplied as pictured with custom firewall mount, factory muffler, manual and plug wrench. - $525.00
Safety Hub
Click image to enlarge
Our CNC machined replacement prop hub fits all G23, 231 and 260 PU engines. It is designed to eliminate the problem of the weak one piece necked down stud that comes as standard equipment on the PU engines. This design allows you to tighten the prop bolt securely without the worry of snapping the stud. Comes as shown with all high grade hardware. - $39.50
Super Trap, The ultimate air trap (UAT) tank
This 4 oz tank can be used with turbine or gasoline engines to remove air and impurities from the fuel before entering the engine. This is a MUST for turbine engines and is competitively priced at $39.50.